🏗️ How a House Is Built

4th Grade 🏭 How It’s Made

A house doesn’t pop up all at once. It’s built step by step over months: first a strong concrete foundation, then a wooden skeleton, then pipes, wires, walls and paint. In the US, most new houses are built with a wood frame on top of a concrete foundation. In this lesson we follow a house from the drawing to the front-door key.

Free · US Letter · no sign-up
Google Classroom Save to Pinterest Email me

Planning and getting the land ready

Before anyone picks up a hammer, an architect or designer draws what the house will look like and how the rooms will fit together, and engineers make sure it can hold its own weight and stand up to wind, snow and, in some places, earthquakes. The plans go to the city or county, and building can start only after the builder gets a building permit. Inspectors will visit again and again during construction to check the work.

On the lot, surveyors mark exactly where the house will stand. Workers clear the land, and excavators dig out the space for the foundation — a shallow trench, or a deep hole if the house will have a basement. Where the ground is weak, builders may drive or drill deep supports into the ground to carry the weight down to firmer soil.

Concrete: the foundation

Concrete is made of cement, sand, gravel and water. Cement itself is made by grinding up limestone and clay and heating them in a huge rotating kiln to about 2,600°F (about 1,450°C), then grinding the result into a fine gray powder. When cement is mixed with water, a chemical reaction makes the mix harden into artificial stone. Concrete trucks keep their drums turning on the way to the site so the concrete doesn’t start to harden too early.

Concrete is very strong when it’s squeezed but cracks when it’s stretched, so builders lay steel bars called rebar inside it. Together they’re called reinforced concrete. Workers build forms, place the rebar, pour the concrete and wait. Concrete keeps getting stronger for weeks; by common practice, its strength is tested after 28 days. The foundation may be a flat slab, a short crawl space or a full basement, sitting on wide concrete footings that spread the house’s weight over the ground.

Framing: the wooden skeleton

Once the foundation is ready, framers build the skeleton of the house, usually out of lumber. Walls are made of upright boards called studs — often 2×4s or 2×6s — placed about 16 inches (about 40 cm) apart and nailed to boards along the top and bottom. Crews often build each wall flat on the floor and then tip it up into place. Floors rest on wooden joists, and the roof is held up by rafters or by triangle-shaped trusses made in a factory.

Next, the frame is covered with big sheets of plywood or a similar wood panel, which make the walls stiff. A wrap goes over that to keep out rain and wind, and then siding, brick or stucco goes on the outside. The roof gets a waterproof layer and shingles. Wood framing is popular in the US because lumber is plentiful, light and fairly easy to work with — and a skilled crew can frame a whole house in a few weeks.

Systems and finishing

While the walls are still open, electricians run wires and boxes for outlets and switches, plumbers install pipes for hot and cold water and for drains, and other workers put in the ducts for heating and air conditioning. An inspector checks this “rough-in” work before it gets covered up. Then the walls are filled with insulation and covered with drywall, which is taped, smoothed and painted. Floors, cabinets, doors, windows, the kitchen and the bathrooms go in last.

At the end, a final inspection makes sure everything is safe and follows the building code. When the house passes, the owners receive permission to move in, and they get the keys. Safety note: a construction site is a dangerous place, with holes, heavy machines, nails, sharp edges and things that can fall. Kids should never go onto a building site, even when it looks empty.

Key facts

  • Concrete is made of cement, sand, gravel and water.
  • Cement is made from limestone and clay heated in a kiln to about 2,600°F (1,450°C).
  • Reinforced concrete has steel bars (rebar) inside it.
  • By common practice, concrete’s strength is tested after 28 days.
  • Most new US houses have a wood frame on a concrete foundation.
  • Wall studs are often placed about 16 inches apart.

Quick quiz

  1. What is concrete made of?

  2. Why do builders put steel bars in concrete?

  3. What are wall studs?

  4. What does a builder need before starting to build a house?

  5. Why does a concrete truck keep its drum turning?

  6. What do footings do?

  7. What is cement made from?

  8. Why should kids stay off construction sites?

💭 Think and talk about it

  1. Why do you think engineers in some states have to plan for earthquakes or hurricanes?
  2. Why might builders in one place choose wood and builders somewhere else choose concrete or brick?
  3. How many different kinds of workers help build one house? How many can you count?

Questions kids ask

How long does it take to build a house?

It depends on the size and the place. A typical single-family house often takes several months to a year. Weather, permits, inspections and planning all make a big difference.

Why do builders keep fresh concrete damp?

Concrete needs water to keep the chemical reaction going and get stronger. If it dries out too fast in the sun, it can crack.

Can houses be built from other materials?

Yes — from steel, brick, stone, concrete blocks and even mud bricks. Different places choose different materials depending on climate, cost and what’s easy to find.

🔎 Ask Thinkapedia another question